3D printing
Computer mounts, made to measure
SSD adapters, under-desk hooks, monitor risers and cases for bare boards. What a shop does not sell, we design and print.
Computer parts are rarely generic: a screw that does not reach, a board with no case, a tower that does not fit under the desk. We start from the measurements of your setup, draw the part and print it in PETG, which tolerates heat better than PLA.
Ready to order
These models are already designed and tested: fixed price, no design wait.
M.2 SSD Extension Adapter 2230/2242/2260 to 2280
Adapter to mount an M.2 2230, 2242 or 2260 SSD in a 2280 slot using the original standoff screw. PETG plate with side rails. Made in Montevideo.
PETG · 55 × 24 × 3 mm
$400
View in the store
What we have already made to order
M.2 SSD adapter, 2230 to 2280
A short SSD in a slot built for 2280: a plate with side rails that takes the original standoff screw, with break-off lines for 2242 and 2260.
Under-desk hook for the PC case
A hook screwed under the desk that takes a 5 mm rope: the tower hangs from the rope and the floor stays clear.
Monitor base risers
10 × 10 × 60 mm blocks that lift the monitor by 10 mm, so a cable fits underneath or the screen sits at the right height.
Case for a bare board
An enclosure for a Banana Pi board, drawn from the board drawing: port cut-outs, ventilation and seating on the board screws.
What else we can make
Mounts and hooks
For the tower under the desk, the router on the wall, the laptop standing upright or the controller beside the monitor.
Adapters
For drives, fans, bays and screws that do not match what came with the machine.
Cases
For Raspberry Pi, Banana Pi, ESP32 and other boards that arrive without a case or with one that does not fit.
Cable management
Trays, clips and grommets sized to your desk, not to a catalogue.
How to order one
Send measurements and photos
A photo of the spot, the model of the machine and two or three measurements are enough to start. An STL file is even better.
We give you a price
Before printing we tell you the price range and lead time; drawing the part adds design time; printing your STL does not.
We print and check
We print in PETG and check the fit. If something does not sit right, we adjust it.
Frequently asked questions
What are the parts made of?
PETG by default, which tolerates heat better than PLA. If the part calls for something else, we pick the material for the job and tell you first.
Do I need a 3D file?
No. We draw the part from photos and measurements. If you already have an STL from Printables or Thingiverse, we print it as is or adapt it to your machine.
Will a printed mount hold the weight?
It depends on the part, the machine and how it is fixed. We look at each case before printing; if the job needs metal rather than plastic, we tell you instead of printing it.
How much does it cost?
A part that is already designed has a fixed price in the store. A new part depends on its size and the design work: the calculator on the printing page shows a range before you write to us.
Tell us what you need to hold
Send a photo and the measurements: we reply with a proposal and a price range.