3D printing
Custom gears, 3D printed
A broken gear for a machine with no spare parts left, a pulley for a timing belt, a rack for your own project. We measure it, draw it and print it.
A gear is almost always one particular gear: so many teeth, that diameter, this shaft with its key. That is why we do not sell catalogue gears: we start from the broken part or its measurements, work out the tooth profile and print it in PETG. Before the final part, when the fit is in doubt, we print a thin sample to check the mesh against the belt or the mating gear.
What we have made
64-tooth HTD 3M pulley for a keyed shaft
A replacement for a 60 mm pulley on a 15 mm shaft with a 5 mm key: flanges on both sides so the belt stays on, and rounded tooth edges so they do not cut it.
A test ring before the part
A thin ring with the same teeth and another with the same bore: they are tried on the belt and the shaft before the whole pulley is printed, so the fit is corrected without scrapping a large part.
A double pulley for a stepped, threaded shaft
Two 64-tooth HTD 3M pulleys in one piece, 10 mm apart, for a shaft with a slot and an M10 nut. Instead of a pin, the hub has a rib that sits in the slot, and the nut clamps the pulley against the shoulder.
What we can make
Spur gears
Copies of gears from appliances, toys, blinds, printers and tools that are no longer made.
Toothed pulleys
For HTD, GT2 and other belts: tooth count, width and flanges to match your belt.
Racks and pinions
For linear mechanisms in your own projects, models and prototypes.
Bores to measure
Round, keyed, D-flat or hex shaft: the bore is drawn for your shaft, not drilled out afterwards.
What we need from you
The broken part or a photo
Even with teeth missing: we count the ones left and rebuild the rest. If you can bring it, even better.
Three measurements
Outer diameter, width and shaft diameter. If the shaft has a key or a flat, that measurement too.
What it meshes with
The mating gear or the belt: its tooth count, or the code printed on the belt.
How to order one
Send the part or the measurements
From those we work out the module or pitch and the tooth profile.
We give you a price
Before printing we tell you the price range and lead time, design included.
We test and deliver
If the fit is in doubt, we print a thin sample first, then the part. If something does not sit right, we fix it.
Frequently asked questions
Can you copy a gear with missing teeth?
Yes. Counting the teeth that are left and measuring the diameter is enough: that gives the tooth size, and we draw the whole gear.
What are they made of?
PETG by default. If the gear runs hot or under heavy friction, we pick the material for the job and tell you first.
Will a printed gear last like the original?
It depends on how much force it transmits and how fast. We look at the machine before printing; if the job needs a metal gear, we tell you instead of printing it.
How much does it cost?
It depends on the size and on how much measuring and drawing it takes. The calculator on the printing page shows a range before you write to us.
Send us the broken gear
A photo with a ruler beside it and the model of the machine are enough to start: we reply with a proposal and a price range.